READ THIS MAGNETO INSTALLATION GUIDE BEFORE INSTALLING MAGNETO TO ENGINE

1. Confirm that the part number of magneto is approved for the engine installation. Refer to the most current application data at https://powerupignition.aero/
2. BEFORE INSTALLING DRIVE GEARS OR ADAPTERS: Connect a magneto timing tool to the magneto P-Lead and confirm that the contact points open and close by turning the rotor shaft.
3. As required, install magneto drive gears or adapters in accordance with engine manufacturer data. Torque rotor shaft nut to 120 to 320 in. lbs. Install cotter pin and secure.
4. Identify Magneto Rotation
5. Identify ES118T Timing Pin Features
6. Verify that ES118T Timing Pin has been inserted correctly

Insert ES118T Timing Pin into hole that corresponds to magneto ROTATION noted on magneto data plate (ROT.)

NOTE: DO NOT insert Timing Pin based on position of magneto installation on engine

Timing Pin “Step” MUST seat against distributor block

ES118T Timing Pin MUST insert completely through distributor block and distributor gear

WRONG: Timing pin “step is NOT seated against distributor block

CORRECT: Timing pin “step” is seated against distributor block

Page | 1

READ THIS MAGNETO INSTALLATION GUIDE BEFORE INSTALLING MAGNETO TO ENGINE

Timing Pin Inserted Correctly LEFT ROTATION MAGNETO

7. Follow engine manufacturer instructions to set up engine to advance timing position on cylinder number 1.
8. Place gasket between magneto and engine and install magneto onto engine. Install magneto mounting clamps loosely to hold magneto in place but allow for movement of magneto to time to engine.
9. Remove Timing Pin from magneto when magneto when magneto is loosely installed on engine.
10. Adjust contact points to open at engine timing position. Tighten magneto mounting clamp nuts to 190 to 220 in. lbs.
11. Connect ignition P-Leads to magneto capacitor and ground magnetos using the ignition switch.
12. Install ignition harness to magneto.
13. Test run engine in accordance with engine manufacturer instructions.
14. Make appropriate logbook entries to document magneto installation.

Back to view all blog posts